Instructions On Applying Vinyl

When you receive your decal in the mail lay it flat and firmly wipe a credit card or application squeegee across the top of the transfer tape.

Instructions on applying vinyl.

Vinyl decals can take an area from plain to original and fun within a few steps. Using a measuring tape measure the total distance of the surface the vinyl is to be applied to. Maneuver the decal into. Apply masking tape on the area then remove.

While it is fairly simple it is important to follow some guidelines when you are applying. The bottom layer is the backing paper. The top layer is paper transfer tape which is used to apply the decal. Carefully place the transfer tape with vinyl images onto your surface as you would like them to appear.

Do this a few times to tack up the surface plus it removes small pieces of dust and imperfections. Step 2 rub a squeegee or credit card firmly across the sticker through the clear transfer tape to prepare it for application. Step 1 clean the application area with alcohol or soap water. It is simple to the point and will clearly direct your buyer on how to correctly and successfully apply a vinyl decal.

It s important to begin by cleaning the area. Mark this location on the surface using your grease pencil. Peel away the vinyl liner at a 45 degree angle. When looking to start selling items with your silhouette or cricut adhesive vinyl decals are.

Divide the distance by 2 to determine the center point. Peel the backing from the decal exposing the adhesive. Make sure your project surface is clean dry. Place the decal on the car ensuring no part of the decal touches a try spot.

Do not use a glass cleaner because it will leave a residue behind that will prevent the sticker from adhering well. The second layer is the vinyl film which is the decal itself. Spray car generously with the application spray provided or use a mixture of soapy water in a spray bottle. Spray the back of the vinyl as you peel it back.

Step 4 apply decal to cleaned area pressing firmly using squeegee or credit card. Then take a heat gun or hairdryer and warm the surface and even some light heat on the sticker can t hurt don t put too much it can damage it. Step 2 using a squeegee or credit card press firmly on the decal to ensure that the decal sticks to the application transfer paper. Take a look at our instructions guide below so your decal will adhere correctly.

Begin by ensuring the surface has been cleaned and prepared properly. If the vinyl does not separate from the liner simply burnish the transfer tape onto the vinyl and peel away again.